Von Dutch Kustom Cycles Warranty Coverage
WHEN PLAN COVERAGE STARTS AND ENDS
Plan coverage starts from the date you purchase your contract and
continues for the term selected.
All internally lubricated parts;valve covers;intake manifolds;
oil pump; reed valves; engine mounts; cylinder head (s); engine
block/ crankcase and cylinder barrels if damaged as a result of
the failure of an internally lubricated covered engine component.
Waterpump impeller shaft, bearing, bushings and housing; radiator;
cooling fan motor.
All internally lubricated parts contained within the transmission
case; gears; bearing; internal drive selector mechanism and transmission
mounts, transmission case if damaged as a result of the failure
of an internally lubricated transmission component. (clutch assembly
and cable are not covered)
All internally lubricated parts (except clutch and hub assemblies)
contained within the primary drive case; all gears; bearing; internal
drive gears and chains; internal selector mechanism. Primary drive
case if damaged as a result of the failure of a covered primary
DRIVE AXLE ASSEMBLY
(shaft driven motorcycles and atv’s) Differential
housing; final drive housing; all internally lubricated parts
of the forgoing;
axle shafts; constant velocity joints; universal joints; drive
shafts; locking hubs; hub bearings; locking rings; supports.
All internally lubricated parts contained within the front fork
tubes and hub; swing arm bearings or bushings; front and rear wheel
bearings; swing arm; upper and lower control arm; ball joints;
king pins; bushing and spindle, front fork tubes and front hub
if damaged as a result of the failure of a covered suspension component.
Upper and lower steering stem bearing and bearings and bushing;
steering stem; handle bar; steering stem nut, steering stem ends,
steering stem shaft if damaged as a result of the failure of a
covered steering component.
Brake backing plates; brake hubs; calipers; master cylinder assembly;
hydraulic lines an fitting; drum brake actuating cam.
Alternator; starter assembly (only with factory installed compression
release valve); manually operated switches; cooling fan; wiring
harness (as a result of the failure of a covered electrical part);
ignition coil(s); rectifier, stator assembly; rotor assembly; cdi
control box/electronic ignition control module; magneto; electronic
fuel injection control module and Voltage regulator.
All factory instrumentation (mechanical and electronic) and electronic
Petcock; fuel pump and housing; diaphragms; springs; valves and
Digital dash components; control cables; fairing hardware, brackets,
switches, covers, latches and hinges; saddlebag travel trunk latches,
hinges and mounting hardware.
PICK-UP AND DELIVERY SERVICE
When a covered component fails. (Up to $60.00 will be reimbursed.)